Figure 62. Removing A Full Height Add-In Card - Intel SR1530AH - Server System - 0 MB RAM User Manual

5. Remove the screw at the rear of the riser assembly. See letter "A" in
Save this screw. You will use it later.
6. Pull the add-in card from the socket in the riser assembly. You may need to wriggle
the card from front to back to remove it, but use caution so you do not twist or bend
the card. See letter "B" in the figure.
7. Install a filler panel over the opening at the rear of the riser assembly. See letter "C"
in the figure.
8. Re-install the screw you removed in step 5. See letter "A" in the figure.
Note: Make sure that all empty add-in card slots have filler panels installed.
9. Install the PCI riser assembly into the server system. For instructions, see
"Installing the PCI Riser Assembly" on page
10. Install the processor air duct. For instructions, see
Duct" on page
11. Install the server system cover. For instructions, see
Cover".
12. Plug all peripheral devices and the AC power cable into the server.
66
A

Figure 62. Removing a Full Height Add-In Card

33.
®
Intel
C
B
61.
"Installing the Processor Air
Server System SR1530AH / SR1530AHLX / SR1530HAHLX
Figure
AF000675
"Installing the Server System
62.