Related
Documentation
Errata in Documentation for Junos OS Release 10.4 for EX Series Switches
Copyright © 2011, Juniper Networks, Inc.
Layer 2 and Layer 3 Protocols
If there are many joins associated with a neighbor and that neighbor goes down and
comes back up quickly, then those joins might be stranded in an unresolved state until
the
clear pim join
command is issued. [PR/539962: This issue has been resolved.]
PIM join messages sent from an EX8208 switch to a Cisco RP using Auto-RP show the
upstream neighbor as being the EX8208 switch itself and not the Cisco RP. [PR/557130:
This issue has been resolved.]
Management and RMON
On EX4200 switches, the LACP process (
lookup is performed. [PR/533226: This issue has been resolved.]
Virtual Chassis
On an EX4200 Virtual Chassis, after you run the
master-member-id member-id
reboot. That is, you cannot reboot only the master switch on the Virtual Chassis.
[PR/572936: This issue has been resolved.]
New Features in Junos OS Release 10.4 for EX Series Switches on page 187
Changes in Default Behavior and Syntax in Junos OS Release 10.4 for EX Series Switches
on page 189
Limitations in Junos OS Release 10.4 for EX Series Switches on page 190
Outstanding Issues in Junos OS Release 10.4 for EX Series Switches on page 195
Errata in Documentation for Junos OS Release 10.4 for EX Series Switches on page 203
Upgrade and Downgrade Instructions for Junos OS Release 10.4 for EX Series Switches
on page 204
This section lists outstanding issues with the documentation.
J-Web Interface
To access the J-Web interface, your management device requires the following
software:
Supported browsers—Microsoft Internet Explorer version 7.0 or Mozilla Firefox version
3.0
Language support—English-version browsers
Errata in Documentation for Junos OS Release 10.4 for EX Series Switches
) creates core files when an SNMP MIB
lacpd
request system reboot member
command, the master Virtual Chassis member fails to
203