Juniper JUNOS OS 10.4 - RELEASE NOTES REV 5 Release Note page 135

Copyright © 2011, Juniper Networks, Inc.
LSQ Interface CLI on page 137
PT Interface CLI on page 137
T1 Interface CLI on page 137
VLAN Interface CLI on page 138
Aggregated Interface CLI
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
request lacp link-switchover ae0
set interfaces ae0 aggregated-ether-options lacp link-protection
set interfaces ae0 aggregated-ether-options link-protection
ATM Interface CLI
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
set interfaces at-1/0/0 container-options
set interfaces at-1/0/0 atm-options ilmi
set interfaces at-1/0/0 atm-options linear-red-profiles
set interfaces at-1/0/0 atm-options no-payload-scrambler
set interfaces at-1/0/0 atm-options payload-scrambler
set interfaces at-1/0/0 atm-options plp-to-clp
set interfaces at-1/0/0 atm-options scheduler-maps
set interfaces at-1/0/0 unit 0 atm-l2circuit-mode
set interfaces at-1/0/0 unit 0 atm-scheduler-map
set interfaces at-1/0/0 unit 0 cell-bundle-size
set interfaces at-1/0/0 unit 0 compression-device
set interfaces at-1/0/0 unit 0 epd-threshold
set interfaces at-1/0/0 unit 0 inverse-arp
set interfaces at-1/0/0 unit 0 layer2-policer
set interfaces at-1/0/0 unit 0 multicast-vci
set interfaces at-1/0/0 unit 0 multipoint
Unsupported CLI
135