Table of Contents
Advertisement
Copyright © 2011, Juniper Networks, Inc.
Issues in Junos OS Release 10.4 for SRX Series Services Gateways and J Series Services Routers
On all SRX Series devices, the destination and destination-profile options for address
and unnumbered-address within family inet and inet6 were allowed to be specified
within a dynamic profile but were not supported. [PR/493279: This issue has been
resolved.]
On SRX240 and SRX650 devices, IGMP reports were flooded on all ports that were
part of the same multicast group instead of being sent on only the router interface.
[PR/546444: This issue has been resolved.]
On SRX650 devices, IGMP snooping did not work in q-in-q mode on a trunk port when
the Ethernet type was set to any value other than 0x8100. [PR/554992: This issue has
been resolved.]
On SRX100 devices, the maximum number of MTU that can be configured on FE
interface was 1624. Also, MTU configuration from J-Web was not recommended if you
were running Junos Release 10.1 and 10.2. [PR/566592: This issue has been resolved.]
On SRX5800 devices, under certain circumstances, zone screening setting was not
applied properly. [PR/569678: this issue has been resolved.]
Intrusion Detection and Prevention (IDP)
On SRX210 High Memory and SRX240 High Memory devices, IDP scaling drop occurred.
[PR/525732: This issue has been resolved.]
On SRX240 High Memory devices, with IDP policy template, policy load failed while
changing the active policy from the recommended option to the IDP_Default policy.
This was because there was not enough memory for IDP to load the IDP_Default policy.
[PR/539486: This issue has been resolved.]
J-Web
On SRX100 devices, in J-Web, users could configure the scheduler without entering
any stop date. The device submitted the scheduler successfully, but the submitted
value was not displayed on the screen or saved in the device. [PR/439636: This issue
has been resolved.]
On J2350 and SRX210 High Memory devices, you could not use the
for moving the IPS rule in IDP policy page. [PR/499499: This issue has been resolved.]
On SRX Series and J Series devices, in the J-Web interface, the
not work for the exempt rulebase on the IDP Policy configuration page. [PR/503451:
This issue has been resolved.]
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, in J-Web interface, when
you tried to commit a candidate configuration in the CLI using the
an error was displayed on the configuration page. [PR/514771: This issue has been
resolved.]
On SRX220 devices, you could not edit the physical properties of a LAN interface in
J-Web without entering the MAC address. [PR/519818: This issue has been resolved.]
button
Move/edit
button did
Move/edit
Point and Click
CLI,
171
Advertisement
Table of Contents
