Interfaces And Routing - Juniper JUNOS OS 10.4 - RELEASE NOTES REV 5 Release Note

JUNOS OS 10.4 Release Notes
146
In the packet processor on an IOC, the maximum number of three-color-policers is
2000.
The maximum burst size of a policer or three-color-policer is 16 MB.
1G half-duplex mode of operation is not supported in the autonegotiation mode for
the following devices:
SRX650 Services Gateway
16-port GPIM
24-port GPIMs
On SRX650 devices, the T1/E1 GPIMs (2 or 4 port version) do not work in Junos OS
release 9.6R1. This issue is resolved in Junos OS Release 9.6R2 and later releases, but
if you roll back to the 9.6R1 image, this issue is still seen.
The SRX220 Services Gateway does not support the 1-port SFP Mini-PIM.

Interfaces and Routing

On SRX210 devices, the link goes down after an FPGA upgrade is performed. As a
workaround, run the
restart fpc
On SRX240 High Memory devices, traffic might stop between SRX240 device and
CISCO switch due to link mode mismatch. As a workaround, Juniper Networks
recommends setting auto-negotiation parameters on both ends to the same value.
On SRX100 devices, the link goes down when you upgrade FPGA on 1xGE SFP. As a
workaround, run the restart fpc
On SRX210 devices with VDLS2, ATM COS VBR-related functionality cannot be tested
because of lack of support from the vendor.
On SRX210 High Memory devices, IGMP v2 JOINS messages are dropped on an IRB
interface. As a workaround, enable IGMP snooping to use IGMP over IRB interfaces.
On J Series devices, the DS3 interface do not have an option to configure
multilink-frame-relay-uni-nni (MFR).
On SRX210, SRX220 and SRX240 devices, every time the VDSL2 PIM is restarted in
the ADSL mode, the first packet passing through the PIM is dropped.
On SRX240 Low Memory devices and SRX240 High Memory devices, the RPM server
operation does not work when the probe is configured with the option
destination-interface .
Link Layer Discovery Protocol (LLDP)—The following are the LLDP limitations:
On J Series devices, LLDP is not supported on routed ports.
On SRX Series and J Series devices, LLDP over
On SRX Series and J Series devices, LLDP is supported only on interface unit 0.
command.
command and restart the FPC.
ae interfaces is not supported.
Copyright © 2011, Juniper Networks, Inc.