Table of Contents
Advertisement
JUNOS OS 10.4 Release Notes
180
J Series Services Routers Hardware Guide
In the J Series Services Routers Hardware Guide, the procedure "Installing a DRAM
Module" omit the following condition:
All DRAM modules installed in the router must be the same size (in megabytes), type,
and manufacturer. The router might not work properly when DRAM modules of different
sizes, types, or manufacturer are installed.
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware
Guide
In the "SRX Series Services Gateway Interfaces Power and Heat requirements" section,
the PIM Power Consumption Values table contains the power consumption value for
the 1-port Gigabit Ethernet Small Form-Factor Pluggable (SFP) Mini-PIM value as: 3:18
W
The correct power consumption value for the 1-port Gigabit Ethernet Small Form-Factor
Pluggable (SFP) Mini-PIM is 4:4 W
SRX1400 Services Gateway Hardware Guide
The SRX1400 Services Gateway Hardware Guide includes the following caution:
CAUTION: To comply with intrabuilding lightning/surge requirements, intrabuilding
wiring must be shielded, and the shield for the wiring must be grounded at both ends.
This caution is not applicable.
The SRX1400 Services Gateway Hardware Guide includes information about the
following DC-powered SRX1400 Services Gateways:
SRX1400BASE-XGE-DC
SRX1400BASE-GE-DC
These models are not available in Junos OS Release 10.4. Contact your Juniper Networks
customer service representative for information on these models.
Fan tray LED table in the "Replacing the Fan Tray on the SRX1400 Services Gateway"
section of the SRX1400 Services Gateway Hardware Guide erroneously documents
that:
The Amber (On Steadily): Fan tray LED cannot detect fan failure.
The correct information for this section is as follows: Amber LED (on steadily): Fan
tray LED does not indicate fan failure .
Some of the graphics in the SRX1400 Services Gateway Hardware Guide show the
grounding lug attached to the front panel of the device. However, the SRX1400 Services
Gateway is not shipped with grounding lug attached to it.
In the SRX1400 Services Gateway Hardware Guide, the following topics erroneously
document "RE ETHERNET" port as "ETHERNET" port.
Connecting the SRX1400 Services Gateway to a Network for Out-of-Band
Management
Copyright © 2011, Juniper Networks, Inc.
Advertisement
Table of Contents
