Table of Contents
Advertisement
JUNOS OS 10.4 Release Notes
198
Port Troubleshooting page (Troubleshoot > Troubleshoot > Troubleshoot Port)
Static Routing page (Monitor > Routing > Route Information)
Support Information page (Maintain > Customer Support > Support Information)
View Events page (Monitor > Events and Alarms > View Events)
[PR/542887]
If you configure 802.1X on an EX Series switch, the J-Web interface performance slows
down. [PR/543298]
On EX4500 switches and on EX4200-24F switches, the total number of ports displayed
in the dashboard (Dashboard > Capacity Utilization > Total number of ports) in the
J-Web interface increases every 2 seconds, each time an automatic refresh occurs.
[PR/543913]
When you open a J-Web session using HTTPS, then enter a username and password
and click on the
button, the J-Web interface takes 20 seconds longer to launch
Login
and load the Dashboard page than it does if you use HTTP. [PR/549934]
If you navigate to a new page before all the components of a page in the J-Web interface
are loaded, a pop-up window with the error message "Object Expected" is displayed.
[PR/567756]
In the J-Web interface, aggregated Ethernet interfaces are not populated in the Port
Association table. [PR/579555]
Layer 2 and Layer 3 Protocols
On EX8200 switches, if you take a line card offline when GRES and IGMP snooping are
enabled, existing multicast traffic might be affected because indexes are not updated
correctly. [PR/569637]
On an EX4200 Virtual Chassis, when you configure the RPM hardware timestamp with
the
hardware-timestamp
command displays the hardware timestamp status as "No hardware timestamps". As
a workaround, do not configure a source address for RPM probes. Packets are sent
and received on the same interface. This problem does not occur if both egress and
ingress interfaces are on the same Virtual Chassis member. [PR/578734]
configuration statement, the
show services rpm probe-results
Copyright © 2011, Juniper Networks, Inc.
Advertisement
Table of Contents
