Table of Contents
Advertisement
Errata and Changes in Documentation for Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
Related
Documentation
Copyright © 2011, Juniper Networks, Inc.
[Subscriber Access, System Basics]
When you modify dynamic CoS parameters with a RADIUS change of authorization
(CoA) message, the Junos OS accepts invalid configurations. For example, if you specify
that a transmit rate that exceeds the allowed 100 percent, the system does not reject
the configuration and returns unexpected shaping behavior.
[Subscriber Access]
We do not support multicast RIF mapping and ANCP when configured simultaneously
on the same logical interface. For example, we do not support when a multicast VLAN
and ANCP are configured on the same logical interface, and the subscriber VLANs are
the same for both ANCP and multicast.
[Subscriber Access]
The Guidelines for Configuring Dynamic CoS for Subscriber Access topic in the Subscriber
Access Configuration Guide erroneously states that dynamic CoS is supported for
dynamic VLANs on the Trio MPC/MIC family of products. In the current release, dynamic
CoS is supported only on static VLANs on Trio MPC/MIC interfaces.
[Subscriber Access]
The Subscriber Access Configuration Guide incorrectly describes the
statement as it is used for subscriber access management. When configuring the
authentication-order
statement for subscriber access management, you must always
specify the
method. Subscriber access management does not support the
radius
keyword (the default), and authentication fails when you do not specify an
password
authentication method.
[Subscriber Access]
In the Subscriber Access Configuration Guide, the Juniper Networks VSAs Supported by
the AAA Service Framework topic and the Specifying an Address Pool in a Domain Map
topic incorrectly indicate that VSA 26-2 (Local-Address-Pool) is supported. Subscriber
management does not support this VSA.
[Subscriber Access]
User Interface and Configuration
The
show system statistics bridge
routers. [System Basics Command Reference]
VPNs
In Chapter 19, Configuring VPLS of the VPNs Configuration Guide, an incorrect statement
that caused contradictory information about which platforms support LDP BGP
interworking has been removed. The M7i router was also omitted from the list of
supported platforms. The M7i router does support LDP BGP interworking.
[VPNs]
New Features in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
on page 6
command displays system statistics on MX Series
authentication-order
77
Advertisement
Table of Contents
