Table of Contents
Advertisement
JUNOS OS 10.4 Release Notes
164
J-Web
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, the LEDs on the Routing
Engine and PICs are not shown as green when they are up and online on the J-Web
Chassis View. [PR/297693]
On SRX100, SRX210, SRX240, and SRX650 devices, the LED status in the Chassis View
is not in sync with the LED status on the device. [PR/397392]
On SRX210 Low Memory devices, in the rear view of the Chassis View image, the image
of the ExpressCard remains the same whether a 3G card is present or not. [PR/407916]
On SRX Series devices, the CLI Terminal feature does not work in J-Web over IPv6.
[PR/409939]
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, in J-Web, the Generate
Report option under Monitor Event and Alarms opens the report in the same webpage.
[PR/433883]
On SRX100, SRX210, SRX240, SRX650, and all J Series devices, in J-Web, the options
Input filter and Output filter are displayed in the VLAN configuration page. These options
are not supported, and the user cannot obtain or configure any value under these filter
options. [PR/460244]
On SRX100, SRX210, SRX240, SRX650, and all J Series devices, when you have a large
number of static routes configured, and if you have navigated to pages other than to
page 1 in the Route Information table in the J-Web interface (Monitor>Routing>Route
Information), changing the Route Table to query other routes refreshes the page but
does not return you to page 1. For example, if you run the query from page 3 and the
new query returns very few results, the Route Information table continues to display
page 3 with no results. To view the results, navigate to page 1 manually. [PR/476338]
On SRX3400, SRX3600, SRX5600, and SRX5800 devices, the entry registered into
RIB is not shown in J-Web. [PR/483885]
On SRX210 Low Memory, SRX210 High Memory, and SRX210 PoE devices, in the J-Web
interface, Configuration>Routing>Static Routing does not display the IPv4 static route
configured in rib inet.0. [PR/487597]
On SRX100 (Low Memory and High Memory), SRX210 (Low Memory, High Memory,
and PoE), SRX240 (Low Memory and High Memory), SRX650, J2350, J4350, and J6350
devices, CoS feature commits occur without validation messages, even if you have not
made any changes. [PR/495603]
On SRX100, SRX210, SRX220, and SRX240 devices, in J-Web, after a session expires,
a relogin page appears in the wizard window. As a workaround, close the wizard window
when the session expires and log in again. [PR/537475]
On SRX100, SRX210, SRX220, and SRX240 devices, in J-Web, a matching destination
port configured in the NAT wizard is not pushed to the CLI configuration. As a
workaround, use the CLI. [PR/547630]
On SRX100, SRX210, SRX220, and SRX240 devices, wizards take more time to commit
the configuration setup and to load the page. [PR/548530]
Copyright © 2011, Juniper Networks, Inc.
Advertisement
Table of Contents
