Table of Contents
Advertisement
Issues in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
Copyright © 2011, Juniper Networks, Inc.
Issues in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
Issues in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers on page 51
Errata and Changes in Documentation for Junos OS Software Release 10.4 for M Series,
MX Series, and T Series Routers on page 73
Upgrade and Downgrade Instructions for Junos OS Release 10.4 for M Series, MX Series,
and T Series Routers on page 78
The current software release is Release 10.4R2. For information about obtaining the
software packages, see "Upgrade and Downgrade Instructions for Junos OS Release 10.4
for M Series, MX Series, and T Series Routers" on page 78.
Current Software Release on page 51
Previous Releases on page 63
Current Software Release
Outstanding Issues in Junos OS Release 10.4 for M Series, MX Series, and T Series Routers
Class of Service
When a valid rate-limit is configured on an interface from a DPCE-R-Q-20GE-2XGE
card, the router might log a message incorrectly that the configuration is not supported.
The rate-limit functionality is however correctly implemented in the hardware.
[PR/574764]
Forwarding and Sampling
A high CPU utilization by the DFWD process might occur if the interface lo0 is configured
as part of the interface group 0. [PR/497242]
When a VPN routing and forwarding table (VRF) is configured in a logical system, and
there is no loopback filter configured in the VRF while it is configured on the logical
system and the default router, the packets destined for the VRF reach the filter
configured in the logical system. However, they are expected to reach the filter
configured in the default route table. [PR/575060]
On M Series, T Series, and J Series routers, when the installation of a filter that contains
a logical-interface-policer or a physical-interface-policer fails (For example, due to
insufficient jtree memory), the FPC might crash. [PR/579271]
High Availability
The SSH keys are not in sync between the master and backup Routing Engine when
SSH is enabled after a graceful Routing Engine switchover (GRES). [PR/455062]
Interfaces and Chassis
When the Rx power level is a negative value, the SFP diagnostics output displays an
invalid receiver power level reading. [PR/235771]
Upon a link up event, old packets from the previous link down are still dequeued. This
leads to huge latency reports. [PR/515842]
51
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOS OS 10.4 - RELEASE NOTES REV 5 and is the answer not in the manual?
Questions and answers