Table of Contents
Advertisement
Copyright © 2011, Juniper Networks, Inc.
IP Interface CLI
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
set interfaces ip-0/0/0 unit 0 layer2-policer
set interfaces ip-0/0/0 unit 0 ppp-options
set interfaces ip-0/0/0 unit 0 radio-router
LSQ Interface CLI
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
set interfaces lsq-0/0/0 unit 0 layer2-policer
set interfaces lsq-0/0/0 unit 0 family ccc
set interfaces lsq-0/0/0 unit 0 family tcc
set interfaces lsq-0/0/0 unit 0 family vpls
set interfaces lsq-0/0/0 unit 0 multipoint
set interfaces lsq-0/0/0 unit 0 point-to-point
set interfaces lsq-0/0/0 unit 0 radio-router
PT Interface CLI
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
set interfaces pt-1/0/0 gratuitous-arp-reply
set interfaces pt-1/0/0 link-mode
set interfaces pt-1/0/0 no-gratuitous-arp-reply
set interfaces pt-1/0/0 no-gratuitous-arp-request
set interfaces pt-1/0/0 vlan-tagging
set interfaces pt-1/0/0 unit 0 radio-router
set interfaces pt-1/0/0 unit 0 vlan-id
T1 Interface CLI
The following CLI commands are not supported. However, if you enter these commands
in the CLI editor, they appear to succeed and do not display an error message.
set interfaces t1-1/0/0 receive-bucket
Unsupported CLI
137
Advertisement
Table of Contents
