Table of Contents
Advertisement
JUNOS OS 10.4 Release Notes
192
On 40-port SFP+ line cards installed in EX8200 switches, it takes about 10 seconds
for the network ports to come up after you reboot the switch or restart a line card.
On the LCD Panel, in the Menu Options, under the
option
Request VC Port
with the further option
standalone EX4500 switches even though these options are displayed on the LCD
Panel.
High Availability
On EX8216 switches on which nonstop active routing (NSR) is configured, after a
graceful Routing Engine switchover (GRES), the routing protocol process (
be delayed until state replication finishes. The duration of the delay depends on the
scale of the setup. During this delay, operational mode commands for the
do not provide current information.
Infrastructure
If you configure interface parameters on an EX3200 or an EX4200 switch running Junos
OS Release 9.2 or Release 9.3 for EX Series switches and then attempt to upgrade to
a later release or a later version of Release 9.3 than the one that is currently installed,
the switch might display the following error message: "init: interface-control is thrashing
, not restarted". As a workaround, on the interfaces you had previously configured,
configure
no-auto-negotiation
revised configuration.
On EX Series switches, an SNMP query fails when the SNMP index size of a table is
greater than 128 bytes, because the Net SNMP tool does not support SNMP index sizes
greater than 128 bytes.
On EX Series switches, the
any output, even though the
are not populated at the module level—they are populated at the table level only. You
can issue
show snmp mib walk dot3StatsTable
and
show snmp mib walk dot3ControlTable
table level.
When you issue the
request system power-off
turning off power.
In the J-Web interface, the Ethernet Switching Monitor page might not display
monitoring details if the switch has more than 13,000 MAC entries..
In the J-Web interface, changing the port role from Desktop, Desktop and Phone, or
Layer 2 Uplink to another port role might not remove the configurations for enabling
dynamic ARP inspection and DHCP snooping.
On EX3200 and EX4200 switches that are configured with the factory default
configuration, if you use the command
the date but display the following error message: "date: connect: Can't assign requested
address".
On EX8208 switches, when a line card that has no interface configurations and is not
connected to any device is taken offline using the command
MAINT (Maintenance Menu)
Set FPC 0?
and set the link mode to
show snmp mib walk etherMIB
is supported. This occurs because the values
etherMIB
,
show snmp mib walk dot3PauseTable
commands to display the output at the
command, the switch halts instead of
set date
to change the date, the switches accept
Copyright © 2011, Juniper Networks, Inc.
, the
, is not supported on
) might
rpd
process
rpd
full-duplex
, then commit the
command does not display
request chassis fpc-slot
,
Advertisement
Table of Contents
