Table of Contents
Advertisement
JUNOS OS 10.4 Release Notes
40
[Interfaces Command Reference]
Enhancement to
show oam ethernet connectivity-fault-management
output of the
show oam ethernet connectivity-fault-management mep-statistics
oam ethernet connectivity-fault-management interfaces
connectivity-fault-management mep-database
new fields:
Out of sync 1DMs received
delay measurement packets received;
of valid two-way delay measurement request packets received, and
received
, which displays the number of invalid two-way delay measurement request
packets received.
[Interfaces Command Reference]
New command to clear ETH-DM delay-statistics (MX Series routers)—A new
command,
clear oam ethernet connectivity-fault-management delay-statistics
you to clear ITU-T Y.1731 Ethernet frame delay measurement (ETH-DM) delay-statistics
and ETH-DM frame counts. Use the
maintenance-association-name
options to clear delay-statistics and frame counts for specific maintenance associations
and maintenance domains. You can also use the
clear only one-way delay statistics or two-way delay statistics, respectively.
[Interfaces Command Reference]
Circuit Emulation (CE) interfaces firmware compatibility for ATM IMA on M7i, M10i,
M40e, M120, and M320 routers—Provides a
a
command output message in the IMA Group state and IMA Link state
show interface
if the PIC's firmware is not compatible in Junos OS Release 10.0 and later releases.
NOTE: CE PICs require firmware version
for ATM IMA functionality on M7i, M10i, M40e, M120, and M320 routers with
Junos OS Release 10.0R1.
CE PICs manufactured with the 560-028081.pbin firmware will produce the following
entry in /var/log/messages when Junos OS is upgraded to Release 10.0R1 or newer
releases:
Firmware mismatch. Need to upgrade PIC PROM Binary CPU firmware for IMA.
If you configure IMA with this combination of Junos OS and CE PIC firmware, the
following entry will be seen.
Firmware error. Need to upgrade PIC PROM Binary CPU firmware for IMA.
The
show interfaces ce-fpc/pic/port
Physical link is Down
IMA Group state
: NE: Firmware Error
IMA Link state
: Line: Firmware Error
The customer must contact JTAC for a PIC firmware upgrade to proceed with IMA.
[Interfaces Command Reference, System Log Messages Reference]
, and
commands includes the following three
, which displays the number of out-of-sync one-way
Valid DMMs received
maintenance-association
and
maintenance-domain maintenance-domain-name
one-way
Firmware mismatch
rom-ce-9.3.pbin
command output will show the following:
Copyright © 2011, Juniper Networks, Inc.
commands—The
,
show
show oam ethernet
, which displays the number
Invalid DMMs
, enables
and
two-way
options to
syslog message and
or
rom-ce-10.0.pbin
Advertisement
Table of Contents
