Configuring High Availability - Juniper NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1 Quick Start Manual

Hide thumbs Also See for NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1:

Table of Contents

Configuring High Availability

Enter the primary IP address of your management server for eth0 (the default).

You can use the default IP address next to the first radio button or select the second

radio button and then enter a different IP address. Each IP address you add (in addition

to the default IP address) will be available in the drop-down list after you click the

second radio button.

Enter the NSM superuser password in the top text box, and then reenter it in the text

box below it.

This password must be at least eight characters long and is case-sensitive. This

password is used by the NSM superuser (also referred to as the NSM administrator).

This user has the highest level of privileges in NSM.

Enter the GUI Server one-time password in the top text box, and then reenter it in the

text box below it. This password is used to authenticate this NSM server with other

NSM servers with which it communicates. Regional servers use this password to

authenticate peer servers in an HA configuration and to authenticate the central

manager. The central manager uses this password to authenticate its peer server in

an HA configuration and any regional servers it manages. NSM servers must have the

same GUI Server one-time password, or the authentication will fail.

Select the license option. (This option is available only for regional servers.)

a. Select Base Install to use the built-in limited device license for as many as 25

devices.

b. Click Upload license file to upload the license file you generated using the Juniper

License Management System (LMS), which permits you to manage more than 25

devices. This license file must be located on your local hard drive.

See the Network and Security Manager installation Guide for more information about

NSM licensing.

Click Submit to save any changes, and then click Install to install the software.

10.

To configure high availability (HA) settings:

Configuring the NSM Software

Table of Contents