Hardware Maintenance Tasks-Mars 100, 100E, 200, Gcm, And Gc; Replacing The Lithium Cell Cmos Battery - Cisco CS-MARS-20-K9 - Security MARS 20 User Manual

Chapter 24 System Maintenance
•
In addition, the following reports appear under the System: CS-MARS Issue category.
•
•
•
•
•
•
Hardware Maintenance Tasks—MARS 100, 100E, 200, GCM,
and GC

Replacing the Lithium Cell CMOS Battery

This section pertains only to the MARS 100, 100E, 200, GCM, and GC appliances.
Take proper electrostatic discharge (ESD) measures before physically touching the appliance.
Note
If the CMOS battery needs replacement, follow these steps:
Turn the appliance's power off.
Step 1
Unplug the appliance from the wall electrical socket.
Step 2
Locate the lithium cell CMOS battery.
Step 3
Remove it.
Step 4
Step 5 Set the new battery in its place.
Step 6 Plug the appliance into the electrical socket in the wall.
Turn the appliance's power on.
Step 7
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with
Warning
the same or equivalent type recommended by the manufacturer. Dispose of used batteries according
to the manufacturer's instructions. Statement 1015
78-17020-01
System Rule: CS-MARS Failure Saving Certificates/Fingerprints. This inspection rule indicates
that MARS has failed to save a new or changed device SSL certificate or SSH key fingerprint based
on either explicit user action or automatic accept as specified on the SSL/SSH Settings page.
Activity: CS-MARS Accepted New Certificates/Fingerprints
Activity: CS-MARS Accepted Conflicting Certificates/Fingerprints
Activity: CS-MARS Detected Conflicting Certificates/Fingerprints
Activity: CS-MARS Accepted New Certificates/Fingerprints'
Activity: CS-MARS Failure Saving Certificates/Fingerprints
Activity: CS-MARS Device Connectivity Errors
Hardware Maintenance Tasks—MARS 100, 100E, 200, GCM, and GC
User Guide for Cisco Security MARS Local Controller
24-11