Supported Hardware Components - Cisco Catalyst 9800-80 Installation Manual

Supported Hardware Components

This chapter contains information about the supported hardware components on the Cisco Catalyst 9800-80
Wireless Controller.
•
•
•
•
•
Supported EPA
The following table lists the supported EPA on the Cisco Catalyst 9800-80 Wireless Controller.
PID
EPA-18X1GE
EPA-10X10GE
EPA-1X40GE
EPA-2X40GE
EPA-1X100GE
An EPA has two types of LEDs: an A/L (Active/Link) LED for each port on the EPA, and a STATUS LED,
as shown in the following figure.
Supported EPA, on page 11
Supported SFP Models, on page 13
Supported Transceivers, on page 14
Supported Crypto Module, on page 15
Power Supplies, on page 15
C H A P T E R
Description
Eighteen 1GE-ports that support small form-factor pluggable (SFP)
optical transceivers to provide network connectivity. Ports are numbered
0 – 17.
See the Supported SFP Transceivers section, for supported transceivers.
Ten 10GE-ports that support small form-factor pluggable (SFP+) optical
transceivers to provide network connectivity. Ports are numbered 0 – 9.
See Table 3: Supported SFP Transceivers, for supported transceivers.
EPA-1X100GE uses a CPAK module to provide network connectivity.
See Table 5: Supported CPAK Interface, for supported
CPAKs.
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
2
11