Checklist For Security Manager-To-Mars Integration - Cisco CS-MARS-20-K9 - Security MARS 20 User Manual

Checklist for Security Manager-to-MARS Integration

Checklist for Security Manager-to-MARS Integration
Security Manager-to-MARS integration deals with identifying the required and optional points of
integration, configuring the applications and devices, and ensuring proper authorization among the two
management platforms. This checklist assumes a greenfield install of both Security Manager and MARS.
The following checklist describes the tasks required to understand the decision-making process and the
basic flow required to integrate MARS with a Security Manager server and the reporting and mitigation
devices managed by that Security Manager server. Each step might contain several substeps; the steps
and substeps should be performed in order. The checklist contains references to the specific procedures
used to perform each task.
For a comprehensive checklist on configuring MARS to operate most effectively as an STM, see
Note
STM Task Flow Overview, page
User Guide for Cisco Security MARS Local Controller
16-6
An error occurred while querying policies from Cisco Security Manager. Reason:
Failed to retrieve policy information from CSM. Reason: Cisco Security Manager
Internal error: Failed to get interfaces in the device!
The device LC2DTM was discovered by CSM without any errors.
Before you perform policy queries, verify that all discovered devices have been submitted in
Security Manager.
Chapter 16
1-1.
Policy Table Lookup on Cisco Security Manager
78-17020-01