Table of Contents
Advertisement
Chapter 23
Management Tab Overview
If you are creating a notification by pager, go to the next section,
Step 5
phone/Pager)", otherwise click Submit to complete the procedure for adding a user.
Add a Service Provider (Cell phone/Pager)
When configuring a notification by pager, add a service provider (cell phone or pager company) by
completing the following procedure:
Step 1
From the Service Provider field, select New Provider. Additional fields appear, as shown in
Figure
The pull-down menu is populated as you add new service providers.
Figure 23-5
In the Provider Name field, enter the name of the service provider.
Step 2
In the Provider Phone No field, enter the service provider's telephone number.
Step 3
This is the number the service provider uses for accepting alpha-numeric messages using the IXO/TAP
protocol. The format is like a regular phone number, such as: 18001234567. The format of
1-800-1234567 is also acceptable. If dialing "9" is required to access a number outside your private
branch exchange, type a "9," before the full telephone number (for example, 9,1-800-1234567).
In the Provider Baudrate field, enter the baud rate specified by the provider.
Step 4
This is the baud rate the service provider requires for the specified phone number. Common values are
1200, 2400, 4800, and 9600.
Consult your service provider's website for more information on their baud rates.
Click Submit to close the User Configuration page and return to the User Management tab.
Step 5
Search for a User
Enter the text that you want to search for in the Search field.
Step 1
Click Search.
Step 2
78-17020-01
23-5.
Select a New Provider and Provide Contact Details
"Add a Service Provider (Cell
User Guide for Cisco Security MARS Local Controller
User Management
23-11
Advertisement
Table of Contents
Troubleshooting
