Table of Contents
Advertisement
NetScreen IDP 2.1
From the main menu, click Tools > Preferences.
Step 3
In the tree on the left, click Management Server, enter the Local Controller's address in the Syslog host
Step 4
field, and click OK.
Click Security Policies, and the name of your policy.
Step 5
In the Notification column, right-click anywhere in the cell in the field and select Configure.
Step 6
Check enable logging and syslog for each policy, and click OK. Repeat for all of your policies.
Step 7
From the main menu, click Policy > Install.
Step 8
MARS-side Configuration
Add Configuration Information for the IDP
Click Admin > System Setup > Security and Monitor Devices > Add.
Step 1
From the Device Type list, select Add SW Security apps on a new host or Add SW security apps on
Step 2
existing host.
Enter the Device Name and IP Addresses if adding a new host.
Step 3
Step 4
Click Apply.
Step 5
Click Reporting Applications tab.
From the Select Application list, select NetScreen IDP 2.1.
Step 6
Click Add.
Step 7
Figure 6-17
Add NetScreen IDP 2.1 Sensors Manually
Click Add Sensor.
Step 1
Select existing device or Add New device.
Step 2
Enter the Device Name, Sensor Name, and its Reporting IP address.
Step 3
•
User Guide for Cisco Security MARS Local Controller
6-32
Add NetScreen IDP 2.1 Sensors
Device Name – the DNS entry for this device
Chapter 6
Configuring Network-based IDS and IPS Devices
78-17020-01
Advertisement
Table of Contents
Troubleshooting
