Cisco CS-MARS-20-K9 - Security MARS 20 User Manual page 496

Hardware Maintenance Tasks—MARS 100, 100E, 200, GCM, and GC
The raidstatus CLI command
The raidstatus CLI command reports the current status of the RAID 10 array.
output of the raidstatus command executed on a Local Controller 200.
output fields.
Example 24-1 Example of raidstatus CLI Command Output
[PNADMIN]$ raidstatus
CONTROLLER: C0
-------------
DRIVER:
MODEL:
FW:
BIOS:
MONITOR:
SERIAL #: L14104A5090383
PCB:
PCHIP:
ACHIP:
# OF UNITS: 1
UNIT 0: RAID 10 931.54 GB ( 1953580032 BLOCKS): REBUILDING (75%)
# OF PORTS: 8
PORT 0: WDC WD2500JB-19GVA0 WD-WCAL73129135 232.88 GB (488397168 BLOCKS)
: OK(UNIT 0)
PORT 1: WDC WD2500JB-19GVA0 WD-WCAL73291174 232.88 GB (488397168 BLOCKS)
: OK(UNIT 0)
PORT 2: WDC WD2500JB-19GVA0 WD-WCAL73157538 232.88 GB (488397168 BLOCKS)
: OK(NO UNIT)
PORT 3: WDC WD2500JB-98GVA0 WD-WMAL72243570 232.88 GB (488397168 BLOCKS)
: OK(UNIT 0)
PORT 4: WDC WD2500JB-00GVA0 WD-WCAL73883655 232.88 GB (488397168 BLOCKS)
: OK(UNIT 0)
PORT 5: WDC WD2500JB-19GVA0 WD-WCAL73290905 232.88 GB (488397168 BLOCKS)
: OK(UNIT 0)
PORT 6: WDC WD2500JB-98GVA0 WD-WCAL73693347 232.88 GB (488397168 BLOCKS)
: OK(UNIT 0)
PORT 7: WDC WD2500JB-98GVA0 WD-WMAL72244432 232.88 GB (488397168 BLOCKS)
: OK(UNIT 0)
UNIT /C0/U0
---------------------
STATUS:
UNIT TYPE:
STRIPE SIZE:
SIZE:
# OF SUBUNITS: 4
SUBUNIT 0:
SUBUNIT 0:
PHYSICAL PORT: 7
LOGICAL
SUBUNIT 1:
PHYSICAL PORT: 4
LOGICAL
SUBUNIT 1:
User Guide for Cisco Security MARS Local Controller
24-14
1.02.00.037
7506-8
FE7X 1.05.00.068
BE7X 1.08.00.048
ME7X 1.01.00.040
REV4
1.30-66
3.20
REBUILDING
RAID 10
64K
931.54 GB (1953580032 BLOCKS)
RAID 1: OK
CBOD: OK
PORT: 0
CBOD: OK
PORT: 1
RAID 1: REBUILDING (1%)
Chapter 24 System Maintenance
Example 24-1 displays the
Table 24-1 describes the relevant
78-17020-01