Cisco CS-MARS-20-K9 - Security MARS 20 User Manual page 202

Cisco IPS Modules
For Cisco switches, you can also add a Cisco IPS 4.0 module or an IDS 3.1 module. You configure these
modules just as you would a standalone sensor. For instructions on configuring these modules, refer to
Cisco IDS 3.1 Sensors, page 6-1
Figure 6-8
Enter the hostname of the sensor in the Device Name field.
Step 5
Enter the administrative IP address in the Reporting IP field.
Step 6
The Reporting IP address is the same address as the administrative IP address.
Step 7
In the Login field, enter the username associated with the administrative account that will be used to
Step 8
access the reporting device.
In the Password field, enter the password associated with the username specified in the Login field.
Step 9
In the Port field, enter the TCP port on which the webserver running on the sensor listens.
Step 10
The default HTTPS port is 443.
Note While it is possible to configure HTTP only, MARS requires HTTPS.
Step 11 For attack path calculation and mitigation, specify the networks being monitored by the sensor. Do one
of the following:
User Guide for Cisco Security MARS Local Controller
6-12
and Cisco IDS 4.0 and IPS 5.x Sensors, page
Configure Cisco IPS 5.x
Chapter 6 Configuring Network-based IDS and IPS Devices
6-5.
78-17020-01