Table of Contents
Advertisement
Cisco Switch Devices
•
•
•
•
Enable SNMP Administrative Access
To enable configuration discovery using SNMP access to the Cisco switch, refer to your device
documentation or the following URL:
IP Access
Configure SNMP
Enable Telnet Administrative Access
To enable configuration discovery using Telnet access to the Cisco switch, refer to your device
documentation or the following URL:
IP Access
Enable SSH Administrative Access
To enable configuration discovery using SSH access to the Cisco router or switch, refer to your device
documentation or the following URL:
IP Access
Enable FTP-based Administrative Access
To enable configuration discovery using FTP access, you must place a copy the Cisco router's or
switch's configuration file on an FTP server to which the MARS Appliance has access. This FTP server
must have user authentication enabled.
TFTP is not supported. You must use an FTP server.
Note
You must copy the running configuration from the Cisco switch. For information on copying the running
configuration, refer to your device documentation or the following URL:
User Guide for Cisco Security MARS Local Controller
3-10
Enable SNMP Administrative Access, page 3-10
Enable Telnet Administrative Access, page 3-10
Enable SSH Administrative Access, page 3-10
Enable FTP-based Administrative Access, page 3-10
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_4/confg_gd/ip_perm.htm#wp
1019819
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_4/confg_gd/snmp.htm
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_4/confg_gd/ip_perm.htm#wp
1019819
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_4/confg_gd/ip_perm.htm#wp
1019819
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_8_4/confg_gd/admin.htm#wp10
40556
Chapter 3
Configuring Router and Switch Devices
78-17020-01
Advertisement
Table of Contents
Troubleshooting
