eEye REM 1.0
Configure eEye REM to Generate Required Data
To configure eEye REM to provide the correct data to MARS, follow these steps:
Step 1
Run command svrnetcn at the DOS prompt on the host where eEye REM 1.0 is installed.
In the SQL Server Network Utility dialog box, enable TCP/IP by moving TCP/IP from the Disabled
Step 2
Protocols list to Enabled Protocols list.
Click Apply.
Step 3
Add and Configure the eEye REM Device in MARS
To add the eEye REM device in MARS, follow these steps:
Select Admin > Security and Monitor Devices > Add.
Step 1
User Guide for Cisco Security MARS Local Controller
9-4
Chapter 9
Configuring Vulnerability Assessment Devices
78-17020-01