Add The Cisco 7500 Router With Telnet As The Access Type - Cisco CS-MARS-20-K9 - Security MARS 20 User Manual

Chapter 19 Incident Investigation and Mitigation
TELNET:
Step 5 Click the Test Connectivity button to have the MARS discover the device.
Click the Submit button.
Step 6

Add the Cisco 7500 Router with TELNET as the Access Type

Click Admin > Security and Monitor Devices > Add.
Step 1
Figure 19-17
Step 2 From the Device Type drop-down list, select Cisco Switch-IOS 12.2.
Step 3 Enter the Device Name of the switch.
Enter the Access IP address (optional) and Reporting IP address of the switch. The Reporting IP
Step 4
address is usually the same as the Access IP address, but if you are creating an FTP device it must be a
different IP address.
If you have entered an Access IP address, from the Access Type pull-down menu, select FTP:
78-17020-01
For Enable Password, enter the password to get into Cisco enable mode.
–
Enter its SNMP RO Community.
–
For the Login ID, enter the user name and Password needed to access the switch.
–
For Enable Password, enter the password to get into Cisco enable mode.
–
– Enter its SNMP RO Community.
Configure Cisco IOS 12.2
Layer 2 Path and Mitigation Configuration Example
User Guide for Cisco Security MARS Local Controller
19-21