Setting Runtime Logging Levels - Cisco CS-MARS-20-K9 - Security MARS 20 User Manual

System Maintenance
Revised: April 5, 2007, 78-17020-01
Much of the system maintenance information for the MARS Appliance is provided exclusively in the
Install and Setup Guide for Cisco Security Monitoring, Analysis, and Response System.
The MARS Appliance requires little maintenance. To perform maintenance tasks, you can use the CLI
or the web interface as needed. Some hardware maintenance tasks require physical access to the MARS
Appliance.
This chapter contains the following sections:
•
•
•
•
•
•
•
For information about upgrading, backing up, and restoring data on the MARS Appliance, see the
following sections of the Install and Setup Guide for Cisco Security Monitoring, Analysis, and Response
System:
•
•
•
•

Setting Runtime Logging Levels

To set the appliance's runtime logging levels, navigate to Admin > System Maintenance > Set Runtime
Logging Levels. For typical use, it is best to leave this page set to its defaults.
When you have made your selections, click the Change Logging Levels button.
The following log levels are available:
78-17020-01
Setting Runtime Logging Levels, page 24-1
Viewing the MARS Backend Log Files, page 24-2
Viewing the Audit Trail, page 24-3
Retrieving Raw Messages, page 24-3
Change the Default Password of the Administrator Account, page 24-7
Understanding Certificate and Fingerprint Validation and Management, page 24-7
Hardware Maintenance Tasks—MARS 100, 100E, 200, GCM, and GC, page 24-11
Performing Command Line Administration Tasks, page 6-1
Checklist for Upgrading the Appliance Software, page 6-7
Configuring and Performing Appliance Data Backups, page 6-24
Recovery Management, page 6-35
C H A P T E R
User Guide for Cisco Security MARS Local Controller
24
24-1