Peripheral And Hard Drive Support; 3.5-In Peripheral Drive Bay; 5.25-In Peripheral Drive Bays; Figure 22. Drive Bay Locations For Intel - Intel SC5299BRP Technical Product Specification

®
Intel Entry Server Chassis SC5299-E TPS
4.

Peripheral and Hard Drive Support

Figure 22. Drive Bay Locations for Intel

4.1

3.5-in Peripheral Drive Bay

®
The Intel Entry Server Chassis SC5299-E supports one 3.5-in removable media peripheral,
such as a floppy or tape drive, below the 5.25-in peripheral bays. The bezel must be removed
prior to 3.5-in removable media installation. When a drive is not installed, a snap-in EMI shield
must be in place to ensure regulatory compliance. A cosmetic plastic filler is provided to snap
into the bezel.
The 3.5-in bay is designed for tool-less insertion and removal so that no screws are required.
On the right side of the chassis, two protrusions in the sheet metal help locate the drive. On the
left side are two levers to lock the drive into place.
4.2

5.25-in Peripheral Drive Bays

®
The Intel Entry Server Chassis SC5299-E supports two half-height 5.25-in removable media
peripheral devices, such as a magnetic/optical disk, CD-ROM drive, or tape drive. These
peripherals can be up to 9 inches (228.6 mm) deep on the non-redundant power chassis. The
650-W redundant power supply is longer in length and will limit the drives to approximately 7.5-
in maximum length. As a guideline, the maximum recommended power per device is 17W.
Revision 3.1
A. Hard Disk Drive Bay
®
Entry Server Chassis SC5299-E (DP/WS/BRP
configuration shown)
Intel order number D37594-005
Peripheral and Hard Drive Support
A
TP02032
107