Power On And Off; Switching The Power Off; Switching The Power On - Xerox DocuColor 12 User Manual

1
Press the Power Switch to the Off position to
switch the copier/printer off, as in Figure 1. The
Touch Screen will go dark.
Allow the copier/printer to remain off for
2
approximately 30 seconds if you will be switching
it on again immediately.
3
Press the Power Switch to the On position to
switch the copier/printer on. A message will
display asking you to wait.
After the Power Switch is pressed to On, the
copier/printer takes approximately eight minutes
to come to a Ready to Make Copies condition.
The copier/printer produces colour copies at a rate
of approximately twelve copies per minute,
4
depending on the paper size and the feeding
orientation of the paper.
NOTE: The copier/printer starts automatically
after it comes to the Ready state if the Start button
is pressed during warm-up. A message displays to
indicate that the automatic start feature is
activated. Press the Stop button to cancel the
automatic start feature.
5
CAUTION: The Fuser Roll remains in a cammed-
up position if power to the copier/printer is
interrupted while the copier/printer is in use. If the
Fuser Roll remains in the cammed-up position for
a prolonged period of time, the Fuser Roll can be
damaged and copy quality defects can occur. To
prevent any damage, the copier/printer should be
powered on and a copy made as soon as the
6
power is restored. The Fuser Roll will not be
released from the cammed-up position until the
power is restored, the Power Switch is in the On
position, and the Start button is pressed again.
7
MAKING COPIES

Power on and off

Switching the power off

Switching the power on

Figure 1: Power Switch - Off Position
3–2 DOCUCOLOR 12 USER GUIDE