Invacare LiNX DLX-REM400 User Manual page 44

Invacare® LiNX
4.10.7 Cruise Control
In this mode, you do not have fixed steps and can choose the latched speed by yourself and then remain at that speed for the
A
programmed Latch Drive Timeout period as long as no further demand is given.
Accelerating / Decelerating
1. Give and hold drive demand in direction (forward or reverse) until wheelchair accelerates to desired speed.
2. Release drive demand. Wheelchair speed is held constantly.
3. If maximum drive speed A is not reached, give and hold drive demand again in same direction.
4. Release drive demand. New speed is held constantly.
5. Give drive demand in opposite direction (reverse when driving forwards or forward when driving in reverse) to decelerate speed.
6. Release drive demand. New speed is held constantly.
Stopping
Apart from using an emergency stop or a control input configured for a stop, there are different ways to stop the power wheelchair.
1. Give two short drive demands (less than one second) in same direction to stop at a normal deceleration rate.
2. Give and hold drive demand in opposite direction (reverse when driving forwards or forward when driving in reverse) until power wheelchair
stops. When decelerating in this mode, speed decelerates at rate determined by provider.
Interrupting Deceleration
When stopping (except for an emergency stop or control input configured for a stop), the deceleration can be interrupted to resume driving.
1. Give drive demand for accelerating before speed has reached zero, so speed accelerates to whatever point demand is released.
44 1637423-K