Page 1
Invacare® IDC en Remote User Manual This manual MUST be given to the user of the product. BEFORE using this product, read this manual and save for future reference.
Page 2
All rights reserved. Republication, duplication or modification in whole or in part is prohibited without prior written permission from Invacare. Trademarks are identified by ™and ®. All trademarks are owned by or licensed to Invacare Corporation or its subsidiaries unless otherwise noted.
Directive 93/42/EEC concerning medical devices. It is therefore covered by the power wheelchair’s CE marking. See The IDC is switched on and off using the master remote on the the power wheelchair’s documentation for more information. wheelchair. The wheelchair driver cannot switch back to his own mode by himself using the master remote.
Components 2.2 Bottom side 2 Components 2.1 Top side 1 Connection socket for bus cable 2 Drive button for driving/emergency stop 1 “Reverse activated” LED 2 “Wheelchair driver in control” LED 3 Speed potentiometer 4 “Attendant in control” LED 5 “Driver/attendant” switchover button 6 “ON/OFF”...
8 mm Nm). – Only use the clamping lever provided by Invacare for The IDC is fitted to the wheelchair using a bracket on the push fixing the IDC. handle. There are two variations, one is adjustable and one is fixed –...
Switch the wheelchair electronics off at the master remote. Connect one end of the bus cable to the IDC, the other end to a free bus socket on the wheelchair. In case there is no spare bus socket on the wheelchair’s control system, a splitter / 4–way bus socket can be ordered...
You can carry out further fine The "ON/OFF" and "Wheelchair driver in control" diodes on the adjustments to the maximum speed on the IDC using the speed attendant control display (1) will illuminate.
Invacare® IDC 4.4 Information on the "Emergency Stop" function If the wheelchair needs to be stopped immediately due to a hazard situation, push the drive button (1) firmly as far as possible. This causes an immediate forced drive switch-off. Once you release the drive button (1) you can start to drive the wheelchair again immediately.
Need help?
Do you have a question about the IDC and is the answer not in the manual?
Questions and answers