Engraving - Omtech SH-G570 User Manual

4.3 Engraving

• If there is ever an emergency, hit the Emergency Stop button IMMEDIATELY.
• DO NOT stare continuously at the active laser even while wearing laser
glasses but watch during use for possible issues like sparks and be prepared
to quickly extinguish a fire if necessary.
1. Tap to define the initial launch position for the laser.
This action resets the laser head to the designated starting position or origin point, ensuring it
aligns with the intended starting location of your design.
2. Tap to outline the projected area for engraving or cutting on your material.
The laser traces the boundary, allowing you to ascertain that the laser path is properly aligned
with your material setup.
3. Press to engrave your design.
Again, do not stare continuously at the laser even through the protective polycarbonate window.
Watch for possible issues like sparks or fires, however, and be prepared to quickly extinguish a
fire if necessary.
4. Once the laser has stopped, press
design, and reset the laser head back to its origin.
5. Open the cover and check that the engraved pattern is desired. If not, adjust the parameters as
needed. For parameter reference, see
Remember to press the reset button after temporarily opening and closing
the cover.
6. Remove the sample material and place the actual material for engraving.
7. Press to engrave your design.
to completely stop work, return to the beginning of the
§ 4.6 Instructions for Specific Materials
54
on Page 58.