General Ip Commands; Show; Ping Command; Figure 206 Ip Settings And Default Gateway Address Command Example - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide
The second command changes the default gateway (next hop). This tells the IES-1248 where
to send packets that have a destination IP address that is not on the same subnet as the IES-
1248's IP address.
The third command saves the new configuration to the nonvolatile memory.
For example, use the following command sequence sets the IES-1248 to have 192.168.1.3 as
the IP address, 255.255.255.0 for the subnet mask and 192.168.1.233 for the default gateway.

Figure 206 IP Settings and Default Gateway Address Command Example

ras> ip set 192.168.1.3/24
ras> ip gateway 192.168.1.233
ras> config save
The IES-1248 leaves the factory with a default management IP address of 192.168.1.1 and a
subnet mask of 255.255.255.0, (ff:ff:ff:00 in hexadecimal notation), and the default gateway
set at 192.168.1.254. Make sure that you configure the IP parameters correctly before you
connect a IES-1248 to the network, otherwise, you may interrupt services already running.

52.3 General IP Commands

The following is a list of general IP commands that help with the management of the IP
parameters.

52.3.1 Show

Syntax:
ras> ip show
Use the command to display the current management IP settings.

52.3.2 Ping Command

Syntax:
ras> ip ping <ip> [count]
This is an IP facility to check for network functionality by sending an echo request to another
IP host and waiting for the reply.
348 Chapter 52 IP Commands