Ftp Command Line Procedure; Gui-Based Ftp Clients; Table 71 General Commands For Gui-Based Ftp Clients - ZyXEL Communications P-660W-Tx User Manual

Chapter 17 Maintenance
This is a sample FTP session showing the transfer of the computer file "firmware.bin" to the
ZyXEL Device.
ftp> get config config.rom
This is a sample FTP session saving the current configuration to a file called "config" on your
computer.
If your (T)FTP client does not allow you to have a destination filename different than the
source, you will need to rename them as the ZyXEL Device only recognizes "config" and
"ras". Be sure you keep unaltered copies of both files for later use.
Be sure to upload the correct model firmware as uploading the wrong model
firmware may damage your device.

17.8.2 FTP Command Line Procedure

1 Launch the FTP client on your computer.
2 Enter
3 Press [ENTER] when prompted for a username.
4 Enter your password as requested (the default is "1234").
5 Enter
6 Use
firmware.bin ras
ZyXEL Device and renames it to "ras". Similarly,
the configuration file on your computer (config.cfg) to the ZyXEL Device and renames
it to "config". Likewise
the ZyXEL Device to your computer and renames it to "config". See
181
7 Enter

17.8.3 GUI-based FTP Clients

The following table describes some of the commands that you may see in GUI-based FTP
clients.

Table 71 General Commands for GUI-based FTP Clients

COMMAND
Host Address
Login Type
Transfer Type
182
, followed by a space and the IP address of your ZyXEL Device.
open
to set transfer mode to binary.
bin
to transfer files from the computer to the ZyXEL Device, for example,
put
transfers the firmware on your computer (firmware.bin) to the
get config config.rom
for more information on filename conventions.
to exit the ftp prompt.
quit
DESCRIPTION
Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the server
for anonymous access. Anonymous logins will work only if your ISP or service
administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
Configuration and firmware files should be transferred in binary mode.
put config.rom config
transfers the configuration file on
Table 70 on page
P-660W-Tx v2 User's Guide
put
transfers