Figure 131 Alarm Event Setup; Table 82 Alarm Event Setup - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide

Figure 131 Alarm Event Setup

The following table describes the labels in this screen.

Table 82 Alarm Event Setup

LABEL
Alarm Status
Alarm Port Setup
Index
Alarm
Condition Code
Condition
250
DESCRIPTION
Click Alarm Status to go to a screen that displays the alarms that are currently
in the system (see Section 39.2 on page
Click Alarm Port Setup to go to a screen where you can configure the alarm
severity threshold for recording alarms on an individual port(s). See
on page 252.
This field displays the index number of the alarm in the list. Click this to specify
the severity level of an alarm(s) and where the system is to send the alarm(s).
See Section 39.4.1 on page
This field displays the alarm category to which the alarm belongs.
eqpt represents equipment alarms.
dsl represents Digital Subscriber Line (DSL) alarms.
enet represents Ethernet alarms.
sys represents system alarms.
This field displays the condition code number for the specific alarm message.
This field displays a text description for the condition under which the alarm
applies.
247).
251.
Section 39.5
Chapter 39 Alarm