General Ip Commands; Figure 13-1 Setting Ip Address And Default Gateway - ZyXEL Communications IES-2000 User Manual

IES-2000/3000 User's Guide
For example, if you want the line card to have 172.21.100.1 as the IP address, 255.255.255.0 for the subnet mask
and 172.21.100.254 for the default gateway, you may use the following command sequence:
192.168.1.1> ip
192.168.1.1 ip> enable ether 172.21.100.1
192.168.1.1 ip> subnet delete ether.home
192.168.1.1 ip> subnet add ether.home ether 172.21.100.0 ff:ff:ff:00
192.168.1.1 ip> route delete default
192.168.1.1 ip> route add default 0.0.0.0 172.21.100.254 00:00:00:00
192.168.1.1 ip> config save
Each line card leaves the factory with a default IP address of 192.168.1.1 and a subnet mask of 255.255.255.0, or
FF.FF.FF.0 in hexadecimal notation, and the default gateway set at 192.168.1.254. Make sure that you configure
the IP parameters correctly before you connect a line card to the network, otherwise, you may interrupt services
already running.
13.2

General IP Commands

The following is a list of general IP commands that help with the management of the IP parameters.
13.2.1 Config Command
Syntax:
192.168.1.1 ip> config [save]
This command shows the IP configuration. The save option saves the configuration to the nonvolatile memory.
13-2

Figure 13-1 Setting IP Address and Default Gateway

IP Commands