Ldm Test Parameters; Table 88 Ldm Test Parameters - ZyXEL Communications IES-1248-51 User Manual

Table 87 Log Messages (continued)
LOG MESSAGE
THERMO OVER VOLTAGE:
nominal:<nominal>(mV)
value:<voltage> mV)!
THERMO OVER VOLTAGE
released:
nominal:<nominal>(mV)
value:<voltage> (mV)!

41.3 LDM Test Parameters

The following table lists the line diagnostics test parameters that display, see the ITU-T's
G.992.3 for more information.

Table 88 LDM Test Parameters

LABEL
number_of_
subcarries
hlinScale:
latn:
satn:
snrm:
attndr:
farEndActatp:
i
li.rl
li.im
log
Chapter 41 Diagnostic
TYPE DESCRIPTION
The voltage went outside of the accepted operating range.
WARN
<nominal> - nominal voltage of the DC power
<voltage> - voltage of the DC power when logged
The voltage is back inside the accepted operating range.
INFO
<nominal> - nominal voltage of the DC power
<voltage> - voltage of the DC power when logged
DESCRIPTION
Discrete Multi-Tone (DMT) modulation divides up a line's bandwidth into sub-
carriers (sub-channels) of 4.3125 KHz each.
The first number is the total number of DMT sub-carriers the ADSL connection is
using. The second number indicates how many upstream DMT sub-carriers the
ADSL connection is using.
The channel characteristics function is represented in linear format by a scale
factor and a complex number. These are the maximum upstream and
downstream scale factors used in producing the channel characteristics
function.
This is the upstream and downstream Line Attenuation (in dB).
This is the upstream and downstream Signal Attenuation (in dB).
This is the upstream and downstream Signal-to-Noise Ratio Margin (in dB). A
DMT sub-carrier's SNR is the ratio between the received signal power and the
received noise power. The signal-to-noise ratio margin is the maximum that the
received noise power could increase with the IES-1248 still being able to meet
its transmission targets.
This is the upstream and downstream Attainable Net Data Rate (in bit/s).
This is the upstream and downstream Far End Actual Aggregate Transmit
Power (in dBm)
This is the index number of the DMT sub-carrier.
The channel characteristics function is represented in linear format by a scale
factor and a complex number. This is the real part of the complex number used
in producing the channel characteristics function for this sub-carrier.
The channel characteristics function is represented in linear format by a scale
factor and a complex number. This is the imaginary part of the complex number
used in producing the channel characteristics function for this sub-carrier
This is a format for providing channel characteristics. It provides magnitude
values in a logarithmic scale. This can be used in analyzing the physical
condition of the ADSL line.
IES-1248-51/51A/53 User's Guide
263