Disable Command; Server Set Command; Server Delete Command - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide
This command turns on the DHCP relay feature.

47.1.3 Disable Command

Syntax:
ras> switch dhcprelay disable
This command turns off the DHCP relay feature.

47.1.4 Server Set Command

Syntax:
ras> switch dhcprelay server set <vid> <primary-server> [<secondary-
server>]
where
<vid>
<primary-
server>
<secondary-
server>
This command specifies the DHCP server(s) that serve the specified VLAN. The primary
server is required; the secondary server is optional. The IES-1248 routes DHCP requests to the
specified DHCP server(s) according to the
Use VLAN ID 0 to set up the default DHCP server(s) for all non-listed VLAN.

47.1.5 Server Delete Command

Syntax:
ras> switch dhcprelay server delete <vid> [<primary-server>]
where
<vid>
<primary-
server>
This command deletes all information about DHCP servers for the specified VLAN.
Afterwards, the specified VLAN can uses the default DHCP server(s) set up for VLAN ID 0,
if any.
306
The ID of the VLAN served by the specified DHCP server(s).
=
The IP address of one DHCP server.
=
The IP address of a second DHCP server.
=
relaymode
The ID of the VLAN served by the specified DHCP server(s).
=
The IP address of one DHCP server.
=
. See Section 47.1.7 on page
Chapter 47 DHCP Commands
307.