Igmp Setup Screen; Figure 82 Bandwidth Port Setup; Table 37 Bandwidth Port Setup - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide

Figure 82 Bandwidth Port Setup

The following table describes the labels in this screen.

Table 37 Bandwidth Port Setup

LABEL
Bandwidth Setup
Port
Active
Bandwidth
Select
Active
Inactive
Select All
Select None

20.5 IGMP Setup Screen

Use this screen to configure your IGMP settings.
To open this screen, click Advanced Application, IGMP, IGMP Setup.
170
DESCRIPTION
Click Bandwidth Setup to open the IGMP Bandwidth screen where you can
set up bandwidth requirements for multicast channels (see
168).
This field shows each ADSL port number.
This field shows whether or not multicast bandwidth requirements are enabled
on this port. "V" displays if it is enabled and "-" displays if it is disabled.
Enter the maximum acceptable multicast bandwidth for this port. This has no
effect if bandwidth requirements are disabled.
Select this, and click Active or Inactive to enable or disable the specified
multicast bandwidth requirements on this port.
Click this to enable the specified multicast bandwidth requirements on the
selected port.
Click this to disable the specified multicast bandwidth requirements on the
selected port.
Click this to select all entries in the table.
Click this to un-select all entries in the table.
Section 20.4 on page
Chapter 20 IGMP