This chapter explains how to set the syslog parameters.
36.1 Syslog
The syslog feature sends logs to an external syslog server.
36.2 SysLog Screen
To open this screen, click Advanced Application, SysLog.
Figure 123 SysLog
The following table describes the labels in this screen.
Table 72 SysLog
LABEL
Enable Unix Syslog
Syslog Server IP
Apply
Cancel
Chapter 36 Syslog
C
DESCRIPTION
Select this check box to activate syslog (system logging) and then configure the
syslog parameters described in the following fields.
Enter the IP address of the syslog server. (The log facility is specified in Alarm >
Alarm Event Setup. See
Section 39.4 on page
Click Apply to save your changes to the IES-1248's volatile memory. The IES-
1248 loses these changes if it is turned off or loses power, so use the Config
Save link on the navigation panel to save your changes to the non-volatile
memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
IES-1248-51/51A/53 User's Guide
H A P T E R
Syslog
249.)
3 6
235