2684 Routed Domain Screen; Figure 109 2684 Routed Domain - ZyXEL Communications IES-1248-51 User Manual

IES-1248-51/51A/53 User's Guide
Table 59 2684 Routed PVC (continued)
LABEL
Port
VPI
VCI
IP
DS / US VC Profile
NetMask
Gateway IP
Delete
Cancel

30.3 2684 Routed Domain Screen

Use this screen to configure domains for 2684 routed mode traffic. The domain is the range of
IP addresses behind the subscriber's device (the CPE). This includes the CPE device's LAN IP
addresses and the IP addresses of the LAN computers.
To open this screen, click Advanced Application, 2684 Routed Mode, Routed Domain.

Figure 109 2684 Routed Domain

210
DESCRIPTION
This field displays the number of the ADSL port on which the routed PVC is
configured.
This field displays the Virtual Path Identifier (VPI) The VPI and VCI identify a
channel on this port.
This field displays the Virtual Circuit Identifier (VCI). The VPI and VCI identify a
channel on this port.
This field displays the subscriber's IP address.
This shows which VC profile this channel uses for downstream traffic shaping.
The VC profile for upstream policing also displays if the channel is configured to
use one.
This field displays the bit number of the subnet mask of the subscriber's IP
address.
This field displays the IP address of the gateway to which you want to send the
traffic that the system receives from this PVC.
Select an entry's Delete check box and click Delete to remove the entry.
Clicking Delete saves your changes to the IES-1248's volatile memory.
The IES-1248 loses these changes if it is turned off or loses power, so use the
Config Save link on the navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to start configuring the screen again.
Chapter 30 2684 Routed Mode