Connecting The Machine; Connecting To The Phone Lines - Ricoh MV310 Operator's Manual

Connecting the Machine APPENDIX A: INSTALLATION
Connecting the Machine
Before using the machine, connect the machine to the telephone line properly.
And plug the power cable and switch on.
Make sure that it is properly connected to the telephone line and the power
outlet, as shown below.
CAUTION
Do not switch on until everything is connected properly.
Program the Telephone Line Type setting (use Function 62; see page 41). If
your telephone normally sends out tones(touch tone) when dialing, use the IT
setting; if it normally sends out pulses (rotary dial), use the DP setting. Also,
make sure that the switch on the handset is set up correctly.
Connecting to the Phone lines
Important: By law in the United States, you must program your phone number
identification (your CSI) into your machine before you can connect
it to the public phone system. See page 146.
143