Ricoh MV310 Operator's Manual page 138

APPENDIX A: INSTALLATION
Before installing your machine, read the safety instructions at the beginning of
this manual. To install the machine, follow these procedures:
1-Find a suitable location for the machine.
2-Remove all the pieces of tape attached to the machine and remove the red
clip on the upper unit (See page 131.)
3-install the photoconductor, cleaning pad and toner. (See page 132.)
4-Attach the accessories and load the paper in the drawer. (See page 135.)
5-Connect the phone line. (See page 136.)
6-Connect the power. (See pagel 38.)
7-Enter all necessary information and settings in your machine's memory.
(See page 139.)
Machine Environment
WARNING: When choosing a location for your machine, please follow the
safety instruction given on pages i to iv of this manual.
Location
For the best possible performance, install your machine in a place which
satisfies the following conditions.
c1
c1
c1
c1
D
c1
c1
u
c1
u
u
c1
Not exposed to direct sunlight
Well ventilated (air turnover at least three times per hour); to avoid the
build-up of ozone, make sure to locate the machine in a large well-venti-
lated room which has an air turnover of more than 30 yd3/hr per person.
Level
Not subject to vibration
Away from other electronic equipment, to avoid interference
Away from areas containing corrosive gas
Dust-f ree
Condensation-free
Temperature 63 to 82°F
Humidity 40 to 70% RH (do not install near a humidifier)
Away from heaters and air conditioners, to avoid sudden changes of
temperature
Within 5 yards of a three-pin grounded power outlet (115 Volts, 60 Hz)
129