Errors, Counters, Etc - Ricoh MV310 Operator's Manual

OTHER FEATURES Verifying Communications, Errors, Counters, etc.
Communication Result Report (Memory Transmission) (Switch 03, bit O)
This report is printed out after memory transmission showing whether it was
successful or not. If you have switched this report off, a Communication Failure
Report will be printed when a communication fails.
Transmission Result Report (Switch 03, bit 5)
This report is printed out after immediate transmission showing whether it was
successful or not.
File Reserve Repotl (polling reserve report) (Switch 03, bit 3)
If you switch this report on, it is printed automatically after you program the
machine for polling reception (immediate or send later). It gives the file number,
time of polling, and destinations (including any Group numbers that you
selected).
Communication Result Repoti (polling result repod) (Switch 03, bit 4)
This report is printed after your machine polls a message from another
machine.
Communication Failure Report (ON if Transmission Result Report is OFF)
This report is printed if a memory transmission failure occurred, after a job is
completed. It is only printed if the Transmission Result Report is switched off.
Error Report (Turned on/off by a Service Technician)
This report is printed after each unsuccessful communication. The
communication failure report (above) is printed after a job has been completed.
So while doing a broadcast, the machine may print a number of error reports,
and at the end, it prints a communication failure or transmission result report.
Check it, and retransmit any pages that were not sent. If a particular problem
continues or gets worse, keep the error reports for the service technician.
Printing Part of the Image on the Report (Switch 04, bit 7)
For reference purposes, the machine prints the first few inches of the fax
message on the following reports.
~ Transmission Result Repoti
~ Memory Storage Report
~ Communication Failure Report
48