Ricoh MV310 Operator's Manual page 322

Initial Settings & Adjustments
APPENDIX A: INSTALLATION
If these settings have been made before, the messages on the display will not
always match those shown here. The setting already entered will appear along
with the word [C:HAPil:iE:?]. In this case, press Yes to change the setting.
Press Function and 6, enter the
access code 2222, then enter 61.
You'll get this:
INITIAL MODE Y/NEXT,
E.1 INITIAL 5ET
Press Yes.
Press Yes again.
Enter your phone number.
The format of the number is normally be as follows:
International
Dial Prefix, Your Country Code, Your Area Code, then you
must add a Pause, followed by your telephone
number.
Check the International Dialing Prefix and the Country Code with your lo-
cal telecommunications operator. The example shown is for the USA;
the codes to add are 011 and 1.
Press Yes. F%9GFIACiME~I:! will
flash on the display and you'll get:
Press Yes.
Enter your office, company, or
personal name, or any other ap-
propriate identification. (Use the
quick Dial keys. See page 130 for
details.)
Press Yes. FWXXf?MMED will
flash on the display and you'll get:
::;ET TTI
147