Ricoh MV310 Operator's Manual page 113

Troubleshooting
Operational Difficulties
Operational Difficulties
Problem
Required Action
STANDBYMODE
Nothinghappenswhen the switch is
Checkthe powercord. Is it properlypluggedinto
turned on.
the outlet?
S
Plug
it in firmly
SET DOC. OR DIAL NO. is not
Switch the power on.
displayed.
> If
the Power indicator
does not light, check
that the powercord is pluggedin.
The machinemight be the EnergySaver mode.
> l-foldthe EnergySaver key for two seconds.
The display does not show the
DoesCLEARORIGINALor CLEARGOPY
Readycondition,or the machine
appearin the display?
stops during operation.
> Clearthe misfeed.See page 97.
DoesADD PAPERappearin the display?
> Load paper into the paper tray. See page 79.
DoesCLOSECOVERappear in the display?
> close all covers.
Is the Add Tonerindicatoron?
> Load a new toner cartridge.See page 82.
TRANSMISSION
The original is not pulled into the
You did not feed the document far enough into
auto document feeder,
the feeder.
> Insefl the document into the feeder until it
stops. Retransmit.
Clean the ADF rollers (see page 91).
> If the same problem still exists after user
maintenance, contact your service
representative.
The machine cannot dial out.
The telephone line is disconnected.
> Check that the line is connected properly.
The telephone line type setting is incorrect.
~ Check the telephone line type setting
See page 136.