Emergency Library Access - Quantum PX500 Series User Manual

Emergency Library Access

Quantum PX500 Series User's Guide
4 For the network information such as the IP address to be active, you
must reboot the library by holding down the power button located on
the front of the library (see
The library shuts down.
5 Push the power button to start the library.
The PX502 tape library is initially configured and ready for use.
Use the following procedure to gain access to the tape cartridge
magazines in case of an emergency and the library power is not available.
1 Put on an antistatic wrist strap and clip it to the library chassis
(example: a captive screw on the tape drive cover plates).
Caution: Take standard ESD precautions when performing this
procedure.
2 Insert the metal pick included with the accessory kit into the release
holes and trip the magazine door release for both the right and left
magazine doors (see
The magazine access doors open.
Appendix C Installing the PX502 Library
figure 118).
figure 123).
Emergency Library Access
226