Quantum PX500 Series User Manual page 64

Quantum PX500 Series User's Guide
3 Place cartridges (right side up) in the fixed slots and magazines:
a Open the library doors (see
open the library doors).
Note: In a PX506 and PX510 library, the bottom doors must be
open to open the top doors.
b Remove the magazines (see
release the magazines).
Note: You have approximately 10 seconds to open the doors and
remove the magazines. If you did not complete the
operation, repeat the steps.
Note: In a PX506 and PX510 library, only the bottom magazines
must be released from the OCP. All other magazines can
be removed without being released.
c Load the tape cartridges in the magazines and fixed bins. It is
recommended to start loading tape cartridges in magazine 1, bin
0000 (see "Library Models"
locations).
Warning: Do NOT reach into the library to load tape cartridges
into the fixed bins. Use the
Operations
(see
from the magazines into the fixed bins.
d Replace the magazines in the library.
e Close the library doors.
Caution: Placing the cartridges in the bins upside down can
cause damage to the library (see
cartridges and
Chapter 2 Basic Library Operations
"Library Operations"
"Library Operations"
on page 2 for magazine and bin
tab from the remote management pages
chapter 3 on page 85) to move tape cartridges
figure 21 for LTO cartridges).
Installing Tape Cartridges
on page 68 to
on page 68 to
page located on the
Move
figure 20 for SDLT
41