Figure 113 Px502 Tape Drive Numbering - Quantum PX500 Series User Manual

Figure 113 PX502 Tape Drive
Numbering
Quantum PX500 Series User's Guide
a Insert the tape drive into the drive bay slowly until the
connectors are seated (see
Tape
drive 2
Tighten the tape drive captive screws using a flat blade
b
screwdriver.
c Repeat these steps to install another tape drive in a different
location, if desired.
The library chassis is installed in the rack.
Cabling the Library
Connect the SCSI cables and jumpers as shown in the following figure:
• Figure 114 SCSI System Controller Board
• Figure 115 Surrogate SCSI System Controller Board
• Figure 116 Fibre Channel System Controller Board
• Figure 117 PX502 Stacked Configuration
Appendix C Installing the PX502 Library
Installing the Library
figure 113).
Tape
drive 1
3
216