Quantum PX500 Series User Manual page 179

Event Detail
Ralu rnd number
generator reset
Elem move failed limits
check
Hand-communication
fail
XYZ-communication fail
Timeout waiting for
response (status/taskId)
Z-axis init fail
Z-motor fail (zone #)
Z-position fail (zone #)
X-position fail (zone #)
XY-home fail
XY-motor fail (zone #)
Quantum PX500 Series User's Guide
Event Description
The random number generator
used to calculate the slot locations
for the internal Random Access
Load Unload (RALU) function
has been reset.
A move to an element failed a
calibration limit.
The communications to the
robotic hand has failed.
The communication to the robotic
hardware for moving the X,Y and
Z axis has failed.
A command sent by the
diagnostics module has timed out
waiting for a return from another
module in the system.
The Z (vertical) axis initialization
routine has failed.
The robotic hand has failed to
position the vertical axis to a
predetermined physical location.
The robotic hand has failed to
position the vertical axis to a
predetermined physical location.
The robotic hand has failed to
position the XY axis to a
predetermined physical location.
The XY axis initialization routine
has failed to find its home
position.
The robotic hand has failed to
position the XY axis to a
predetermined physical location.
Chapter 4 SNMP Trap List
Category Reported By
Informational Diagnostics
Warning Diagnostics
Warning Diagnostics
Warning Diagnostics
Critical Diagnostics
Critical Diagnostics
Critical Diagnostics
Critical Diagnostics
Critical Diagnostics
Critical Diagnostics
Critical Diagnostics
156