Setup Mode Entering The Setup Mode At Installation - Intermec EasyCoder F2 Installation And Operation Manual

Setup Mode
Entering
Setup Mode
at Installation
Intermec EasyCoder F2 – Installation & Operation Ed. 1
The method of entering the Setup Mode depends on whether the
printer is fitted with some kind of startup file, a subject that was
more thoroughly discussed in the chapter 4 "Starting Up" earlier
in this manual, to which the alphabetic references below refer.
A. EasyCoder F2 with Intermec Shell
• Turn on the power.
• When the display shows the message "Enter=Shell; x sec.", press
<Enter>.
• Press the <Setup> key (this facility can be used anywhere within
Intermec Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing the <Setup> key.
B. EasyCoder F2 with a custom-made application program
• Normally, there will be no need to enter the Setup Mode for
custom-made application programs. Necessary provisions for
changing the setup, manually or automatically, should be provided
by the program.
Chapter 7
55