About The Laminator Lcd Panel - DataCard RP90 User Manual

Using the LCD menus

About the Laminator LCD panel

When you power on the laminator, it begins initializing. The laminator searches for
laminate and then starts preheating. The laminator is ready when the LCD display reads
"Ready" and the Ready light is steady green.
Ready LED (green)
Steady Green
Blinking
Off
Error LED (red)
On
Off
Keys:
MENU
ENTER
EXIT
RESET/
RP90 Plus E and RL90 User Guide
The laminator is ready.
The laminator busy.
The laminator stopped because of an error, initialization or
preheating is in progress, or the operator is using the LCD panel to
set preferences.
The laminator may require service or did not power on correctly. To
correct the condition, press the RESET/ and then the ENTER key.
If this does not correct the condition, power the laminator off, and
then back on before calling for service.
Normal status
Press MENU to access the laminator settings. Continue to press
the MENU key to access the settings in the order listed on the next
page.
Confirms your selection.
Exits the current selection and returns you to the previous menu
selection. Press the EXIT key at any time to exit the menu system
and return to "Ready" status.
Initializes the laminator after an error occurs. Scrolls through
available values when you change settings.
41